Clarke Focus II Disc 26 Manual De Instrucciones página 14

ENGLISH
EN
HOW TO PREPARE THE MACHINE
FOR OPERATION
How To Install The Brush Or Pad (BOOST Machine)
To install the brush or pad on the machine, follow this
procedure:
1. Turn the key switch "ON".
2. Put the brush head assembly in the "Up" position.
3. Turn the key switch "OFF".
4. Go to the front of the machine.
5. Press on a brush or pad, under the flex plates.
See figure 10.
NOTE: When using a black pad, position pad on head.
Lower head and operate momentarily to affix
pad to pad driver (if you have difficulty, position pad
on floor and lower head then operate.)
How To Remove The Brush Or Pad (BOOST Machine)
To remove the brush or pad from the machine, follow this
procedure:
1. Turn the key switch "ON".
2. Put the brush head assembly in the "Up" position.
3. Turn the key switch "OFF".
4. Go to the front of the machine and pull downward on the
brush or pad until it releases from the flex plates. See
figure 11.
-14-
®
Clarke
Operator's Manual (EN) - FOCUS II MID-SIZE AUTOSCRUBBER
Figure 10
Figure 11
®