Ec Declaration Of Conformity - AL-KO HT 600 FLEXIBLE CUT Instrucciones De Uso

HT 600, HT 700
Troubleshooting
Fault
Machine does not work
Machine cuts out intermit-
tently
Motor runs but blades do
not move
Blades get hot
In the case of faults that are not listed in this table, or faults that you cannot rectify without assistance, please
contact our customer service department.

EC Declaration of Conformity

We hereby declare that this product, in the form marketed by us, meets the requirements of the harmonised
EU directives, the EU safety standards and the product-specific standards.
Product
Electric hedge trimmer
Serial number
G2402405
Type
HT 600 Flexible Cut
HT 700 Flexible Cut
Sound power level
EN ISO 3744
measured / guaranteed
HT 600 Flexible Cut 107 / 107 dB(A)
HT 700 Flexible Cut 103 / 103 dB(A)
470519_e
Possible cause
No power supply
Machine cable defective
Extension lead damaged
ON/OFF switch defective
Internal fault
Internal fault
Insufficient lubrication
Blades blunt
Notching on blades
Manufacturer
AL-KO Geräte GmbH
Ichenhauser Str. 14
D-89359 Kötz
EU directives
2006/42/EG
2014/30/EU
2000/14/EG
Conformity assessment
2000/14/EG, Annex V
Solution
Check fuse / extension lead
Contact AL-KO Service Centre
Check extension lead
Contact AL-KO Service Centre
Contact AL-KO Service Centre
Contact AL-KO Service Centre
Lightly oil blades
Contact AL-KO Service Centre
Contact AL-KO Service Centre
Authorised representative
Andreas Hedrich
Ichenhauser Str. 14
D-89359 Kötz
Harmonised standards
EN 60745-1
EN 60745-2-15
EN 55014-1
EN 55014-2
EN 61000-3-2
EN 61000-3-3
Wolfgang Hergeth, Managing Director
EN
Kötz, 21.07.2016
21