Ec Declaration Of Conformity; Warranty - AL-KO HT 440 BAsic Cut Traducción Del Manual De Instrucciones Original

Ocultar thumbs Ver también para HT 440 BAsic Cut:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
HT 440, HT 550

EC declaration of conformity

We hereby declare that this product, in the form in which it is marketed, meets the requirements of the harmoni-
sed EU guidelines, EU safety standards, and the product-specific standards.
Product
Electric hedge trimmer
Serial number
G 2402405
Model
HT 440 Basic Cut
HT 550 Safety Cut
Sound power level
measured / guaranteed
HT 440
99 / 100 dB(A)
HT 550
97 / 98 dB(A)

Warranty

If any material or manufacturing defects are found during the statutory customer protection period, we will either
repair or replace the equipment, whichever we consider the more appropriate. This statutory period may vary
according to the legislation in force in the country where the equipment was purchased.
Our warranty is valid only if:
The equipment has been used properly
The operating instructions have been followed
Genuine replacement parts have been used
The following are not covered by warranty:
Paint damage due to normal wear
Wear parts identified by a border XXX XXX (X) on the spare parts list
Combustion motors – these are covered by a separate warranty from the manufacturer concerned
To make a claim under warranty, please take this statement of warranty and proof of purchase to the nearest aut-
horised customer service centre. This warranty does not affect the usual statutory rights of the customer relative
to the seller.
470518_c
Manufacturer
AL-KO Geräte GmbH
Ichenhauser Str. 14
D-89359 Kötz
EU guidelines
2006/42/EG
2006/95/EG
2004/108/EG
2000/14/EG
Conformity evaluation
2000/14/EG, Appendix V
The warranty is no longer valid if:
The equipment has been tampered with
Technical modifications have been made
The trimmer was not used for its intended purpose
(for example, used for commercial or communal
applications)
┌──────┐
└──────┘
Executive officer
Anton Eberle
Ichenhauser Str. 14
D-89359 Kötz
Harmonised standards
EN 60745-2-15
Kötz, 25/03/2011
Antonio De Filippo, Managing Director
GB
19

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ht 550 safety cutHt 440 basic cut

Tabla de contenido