Astralpool WELLMA 1-S Manual De Uso E Instalación página 40

ASSEMBLY AND INSTALLATION PROCESS
ASSEMBLING THE BOOTH
The sauna was designed and constructed especially so that it could be
assembled by people whose knowledge in carpentry and electricity is
minimal.
A complete "Kit" is supplied which includes all the necessary pieces and
accessories for the installation. In every unit, complete instructions are
attached that will resolve any doubts or questions that may arise. Each
piece is marked. These marks correspond to each phase of the assembly.
The process on how to complete the installation is perfectly illustrated and
explained. Thus the installation is a pleasant task and should be extremely
easy for any amateur on the subject.
The only tools necessary for complete assembly of the sauna are: A phillips
screwdriver, a flat-head screwdriver, wire cutters and a household ladder.
Assembling the booth should be completed in a 5 key phases:
1. Settle and screw on the complete base frame with its fittings in a
level position and in the location and position you will have the
sauna when it is finished.
2. Insert the modules, together with the corner pieces, into the base
frame in the same order and position shown.
3. Once the perimeter of the walls is closed, insert the 4 pieces of the
upper frame onto the modules as they are marked. Screw in the
frame pieces to each other and to the modules.
4. Insert the ceiling modules into the upper frame and screw them in
against it.
5. Place the interior equipment, seats, hearests, portective fence, etc.,
as detailed and the connection of electrical equipment (specifically
explained).
All the anchorage pieces that are pplied should be used in their correct
place and position to ensure the appropriate settlement and watertightness
of the booth. On the following pages, step by step instructions and
illustrations are given for the installation and assembly ina way that, if none
of the steps ar emised, a perfectly functioning sauna is guaranteed.
Once the packet is
unpacked, we will proceed
to select the different
prices that make up the
lower frame (see figures
1,2,3). We will situate them
in the wat indicated in the
text marked on them
"FRONT, RIGHT, REAR
AND LEFT"
Secure the mentioned
pieces to each other, using
the prefixed iron set
squares on each one and
the 30 mm screws, as
shown in figures 1 and 2.
It is important to bear i
mind that how the lower
frame was situated will
determine the position of
the sauna once it is
assembled. Do not
continue assembling if the
position is not definitive.
When assembling to booth
between interior walls,
centre the notch of the
lower frame of the front to
the space for the door.
FIG Nº 1
FIG Nº 2
FIG Nº 3
7