Astralpool WELLMA 1-S Manual De Uso E Instalación página 51

LANG W25 heater
CLASSIC
In the CLASSIC line, hte anchor
and fastening system of the
fence as well as the position of
the heater are essentially the
same, although in this last case,
the fastening screws for the
fence will be 50 mm. As you can
see, the desing is also different.
ATTENTION:
The heater should always be centred
in the space between the fence and
the sauna walls to avoid overheating.
This model of heater is
suitable for those saunas
where the interior space
isn't very large. Its
dimensions allows for
efficient use of space,
considering the interior
capacity of the booth.
As shown in the figure, the fixing process for this heater is done using the
screws supplied, which will connect it to the wall of the sauna in the
appropriate corner. To carry out this operation, we must first take off the
chrome-plated cover and connect the pre-installed line.
22
FIG Nº 38
FIG Nº 39
FIG Nº 40
Once the heater is connected and fastened to the wall, put the cover back on as
indicated in the figuer.
Finally, put the protective fence in place using the corresponding screws, as
shown in the figure.
The heater will always remain centre in the space between the fence and the
sauna walls to avoid overheating.