Skil 9200 Instrucciones De Funcionamiento Y Seguridad página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SM 2610917364 2/03
2/11/03
Preparing the Saw
BLADE SELECTION
No one blade can be efficient on all cutting
jobs. Different materials require specially
designed blades. Since your reciprocating
saw can cut so many materials, many types of
SKIL blades are available. Be sure to use the
proper blade to insure proper cutting
performance.
INSTALLING A BLADE
Unplug tool from power
WARNING
!
source before changing
blade or making any adjustments.
1. Loosen the socket head cap screw and
open blade clamp with the wrench provided
(Fig. 2).
2. Insert blade shank through opening in
footplate and insert blade between blade
clamp and plunger with hole in blade, engaged
with pin on plunger.
3. Tighten the socket head cap screw and
blade clamp onto the shaft pin with the wrench
provided.
TRIGGER "ON-OFF" SWITCH
TO TURN THE TOOL "ON" squeeze the
trigger switch. TO TURN THE TOOL "OFF",
release the trigger switch, which is spring
loaded and will return to the "OFF" position
automatically.
VARIABLE SPEED DIAL
Your tool is equipped with a variable speed
dial. The blade stroke rate may be adjusted
during cutting operation by presetting the dial
on or between any one of the six numbers.
Setting
SPM rating (strokes per minute)
1-2
Low stroke
3-4
Medium stroke
5-6
High stroke
Higher speed settings are generally used for
fast cutting or when softer cutting materials
such as wood, composite materials, and
plastics. Slower speed settings are generally
used when precision is required or when
cutting harder materials. Materials typically
11:08 AM
Page 7
Assembly
Push in and pull out on the blade to be sure it
is held securely. The blade may be inserted
with the teeth facing up or down.
Note: To prevent blade from coming off,
always make sure hole in blade is engaged
with hole in shaft, and clamp has been
securely tightened.
FIG. 2
SOCKET
HEAD CAP
SCREW
BLADE
Operating Instructions
cut using slower speeds include sheet metal,
conduit, and pipe.
FOOTPLATE ADJUSTMENT
The footplate tilts in order to keep as much of
its surface in contact with the work surface
Fig. 3 . To adjust, hold saw firmly and pivot
footplate to desired position.
FIG. 3
The footplate can also be locked at desired
depths to optimize blade life and/or to limit
-7-
PLUNGER
BLADE
CLAMP
FOOTPLATE
FOOTPLATE

Publicidad

Tabla de contenido
loading

Tabla de contenido