Abicor Binzel ROBO Compact W600 Instructivo De Servicio página 48

9 Maintenance and cleaning
9.5 Cleaning the wire brake (optional version with wire brake)
Carry out each step in accordance with the figure below:
1
1 Torch neck
Fig. 9 Cleaning the wire brake
1 Unscrew the complete wire brake (2) from the torch neck (1).
WARNING
Risk of injury
Serious injuries can be caused by parts swirling around.
• When cleaning the wire guide with compressed air, always wear personal protective
clothing, in particular safety goggles.
2 Disassemble individual parts and air-blast with compressed air.
3 Check the O-rings for wear and replace them if necessary.
4 Grease the piston and O-rings with seal grease (included in the scope of delivery).
5 Remount all individual parts in the reverse order.
EN - 22
A
B
D
2 Wire brake, complete
ROBO Compact W600
C
BAL.0374.0 • 2019-04-01
2