Sanding Walls And Ceilings; Changing The Sanding Disc; Maintenance; Troubleshooting - Menzer TBS 225 Manual Original

Setting the rotation speed:
The rotation speed is fully variable and can be adjusted as required using the rotation speed controller. This
is also possible while the machine is in operation. A higher rotation speed allows for a higher rate of surface

3.2.3 Sanding walls and ceilings

both hands at all times.
scratches and uneven areas in the surface and may also cause damage to the tool itself. It is best to move
too long in one area can leave behind unwanted marks.

3.2.4 Changing the sanding disc

Disconnect the sander from the power supply before changing the sanding disc. Peel the used sanding disc
from the hook & loop pad and place the new disc on it in a centred position. The sanding disc will be held
in place by the hook & loop pad. Choose a suitable grit for the job at hand. Be aware that if the grit is too
wear out the abrasive.
4. STORAGE
The machine must not be exposed to wet or damp storage conditions. The power cable must be discon-
nected from the power source before storage. It must not be used to hang the tool. Always store the sander
out of the reach of children.

5. MAINTENANCE

All air passages and joints must be kept free of dirt and cleaned with compressed air after each use of the
Never use solvents for cleaning the machine.
6 EN

5.1 TROUBLESHOOTING

Problem Possible cause
1. The machine produces too The driving disc or the
much noise.
abrasive may not not be cor-
2. The machine is vibrating rectly fastened.
too heavily.
The machine produces too much 1. The suction tube is clogged.
dust. 2. The dust bag in the industrial
vacuum cleaner is full.
You may be pressing the driving
disc to the surface too hard.
rotation speed.

5.2 REPLACING THE DRIVING DISC

head and turn the look-and-loop pad until you hear the lock make a clicking sound. Turn the hook & loop pad
to the left until it can be removed.

5.3 REPLACING THE BRUSH RIM

The sanding head is surrounded by a brush rim. This ensures that the majority of the dust collected remains
underneath the sanding head and can be extracted by the connected vacuum cleaner. If the brush rim be-
comes worn or damaged it must be replaced.
rim in place and then remove the brush rim itself. Attach the new brush rim and fasten it in place using the
same screws. Now you can re-attach the abrasive.

5.4 REPLACING THE CARBON BRUSHES

The carbon brushes are subject to wear and tear and need to be changed regularly. The inspection and re-
The inspection and replacement of carbon brushes should only be carried out at MENZER service workshops.
Correction
1. Clean the suction system.
2. Empty the bag.
Apply less pressure when using
the machine.
EN 7