When Connecting The External Unit Featuring Video Source; When Connecting The Rear Display; When Using A Rear Display Connected To Rear Video Output - Pioneer AVIC-X3II Manual De Instalación

Section
03 Connecting the System
CAUTION
Be sure to use a CD-RM10 (sold separately) for
wiring. If you use other cables, there is a case
where wiring position differs, images and sounds
may be disturbed.
OK
L
G R
V
When connecting the external
unit featuring video source
The hide-away unit
Yellow
(VIDEO IN)
RCA cable
(sold separately)
To video output
! It is necessary to set [AV1 Input] in
[System] to [EXT] when connecting the ex-
ternal video component. (For details, refer
to the operation manual.)
18
Engb
L : Left audio (White)
R : Right audio (Red)
L
V : Video (Yellow)
G V
R
G : Earth
Blue
IP-BUS cable
(sold separately)
To IP-BUS
output
Pioneer external unit
(sold separately)
When connecting the rear
display
The hide-away unit
Yellow
(VIDEO OUT)
To video input
When using a rear display
connected to rear video output
WARNING
NEVER install the rear display in a location
Black
that enables the driver to watch the video
source while driving.
This navigation system's rear video output is
for connection of a display to enable passen-
gers in the rear seats to watch the video
source.
You can switch the rear screen mode in "AV
MENU". (For details, refer to the operation
manual.)
White, Red
(AUDIO OUT)
RCA cables
(sold separately)
To audio inputs
Rear display with
RCA input jacks