Publicidad
Step 17
Step
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below. Be
å
prepared, the parts are greasy.
Fasten two EXTENSION RAILS (1) to the SMALL ENDS (C and D). Use six BLACK 1/2" PAN HEAD SCREWS (22).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the END. Turn a SCREW into
this hole.
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Push the black lever up and
pull the SLIDE from the RAIL.
Open end
420650
2
BLACK 1/2" PAN HEAD SCREW
The CAM SCREWS
should be here.
1
Surface with
HIDDEN CAMS
www.sauder.com
1
Open end
Use these holes.
22
(6 used in this step)
1
Surface with
HIDDEN CAMS
C
D
Open end
Page 21
Publicidad
