Publicidad
Step 22
Step
Fasten the SHORT TUBES (AA) to the SMALL UPRIGHTS (H and I).
å
Tighten two HIDDEN CAMS.
Fasten one EXTENSION RAIL (1) to the SMALL LEFT UPRIGHT (I). Use
å
three BLACK 1/2" PAN HEAD SCREWS (22).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole
å
shown in the enlarged diagram. Then, slide the inner cartridge of the
EXTENSION RAIL in to fi nd the other hole that lines up with the hole in
the UPRIGHT. Turn a SCREW into this hole.
BLACK 1/2" PAN HEAD SCREW
(3 used in this step)
Page 26
22
www.sauder.com
Surface with
HIDDEN CAMS
H
I
1
Use these holes.
1
I
AA
AA
AA
Open end
Open end
420650
Publicidad
