Publicidad
Step 21
Step
NOTE: Start all of the SCREWS before completely tightening any of them.
å
Fasten the SMALL RIGHT END (C) to the SMALL WIRE BACK (K) and SHORT
å
LEFT TUBES (X). Tighten four BLACK 1-3/8" HEX HEAD SCREWS (16) using
the L-Wrench (14).
Fasten the SMALL RIGHT END (C) to the LEFT BOTTOM (W). Tighten three
å
BLACK 1/2" HEX HEAD SCREWS (20) using the L-Wrench (14).
NOTE: Now, completely tighten all of the SCREWS from Steps 20-21.
å
14
X
BLACK 1/2" HEX HEAD SCREW
(3 used in this step)
420650
W
K
20
www.sauder.com
BLACK 1-3/8" HEX HEAD SCREW
C
X
16
(4 used in this step)
Page 25
Publicidad
