Disposal; Environmental Protection; Extension And Conversion; Troubleshooting - Bosch Rexroth SB356 Manual Del Usuario

40/124
CAUTION
Damage to the SB356 system
box or tightening system if
plug-in connections are
connected or disconnected
while under voltage!
y First switch off the system at
the power switch and then at
the mains or pre-fuse. Allow for
a minimum discharging time of
10 seconds.
CAUTION
Risk of damage to persons
and property!
y First switch off the system at
the power switch and then at
the mains or pre-fuse before
working on the terminals. Allow
for a minimum discharging time
of 10 seconds.
y Check that the terminals are
not under voltage.
CAUTION
Risk of damage to persons
and property!
y Once the device has been
switched off, it cannot be
switched back on again until at
least 30 seconds have
elapsed.
Bosch Rexroth AGSB356 | 3 609 929 B67/2008-11
Proceed as follows to disassemble the
SB356 system box:
1. First switch off the system at the power
switch and then at the mains or pre-fuse.
Allow for a minimum discharging time of
10 seconds.
2. Loosen the main power lines from the
system box.
3. Loosen the knurled bolts on the front for
all components and remove them.
4. Mount dummy panels, if necessary.
12

Disposal

Environmental protection

Careless disposal of the SB356 system box
could lead to pollution of the environment.
Therefore, dispose of the device in
accordance with the currently applicable
regulations in your country. You can also
send the device to Bosch Rexroth for
disposal.
13 Extension and
conversion
Do not convert the SB356 system box.
14

Troubleshooting

Malfunctions and information on errors are
displayed in the tightening system via the
BS350.
If you are not able to remedy an occurring
defect, please contact one of the addresses
that you can find under
www. boschrexroth.com or in the address
directory in chapter "16 Service and sales"
on page 42.