Before Use; Fitting/Changing The Saw Blade; Turning The Handle; Adjusting The Footplate - Parkside PFS 710 C2 Traducción Del Manual De Instrucciones Original

Before use

Fitting/changing the saw blade

WARNING!
► Always remove the plug from the power socket
before working on the appliance.
Otherwise, there is a risk of injury.
♦ Turn the quick-release chuck
this position.
♦ Press the required saw blade as far as it will go
GB
into the quick-release chuck
MT
♦ Release the quick-release chuck
return to its initial position. The saw blade is
now locked.

Turning the handle

RISK OF INJURY!
► Always remove the plug from the power socket
before working on the appliance. The handle
can be turned by 90° to the right or left.
This allows the ON / OFF switch
turned to a most suitable position depending
on the working condition.
♦ Press the release button
to the right or left.
♦ Allow the handle

Adjusting the footplate

RISK OF INJURY!
► Always remove the plug from the power
socket before working on the appliance.
♦ Adjust the footplate
depth.
♦ To do so, loosen the locking lever
the footplate
♦ Lock this position by tightening the locking lever
.
36
and hold it in
.
, it must
to be
and turn the handle
to engage.
according to the cutting
and move
to the corresponding position.

Stroke rate selection

Use the adjusting wheel
stroke rate (– = lower stroke rate, + = increased
stroke rate).
The stroke rate can also be changed during opera-
tion.

Operation

Switching on and off
During operation, you can choose between instan-
taneous and continuous operation.
Switching to instantaneous operation:
♦ Press the ON / OFF switch
light comes on with a slightly or fully pressed
ON /OFF switch
ing area in poor lighting conditions.
Switching off instantaneous operation:
♦ Release the ON / OFF switch
Switching to continuous operation:
♦ Press the ON / OFF switch
position with the locking switch
Switching off continuous operation:
♦ Press the ON / OFF switch
again.

Guiding the sabre blade safely

To adapt to the workpiece and for safe placement,
the footplate can be swivelled. It must always
make contact with the workpiece when the appli-
ance is running.

Practical advice on sawing

♦ Check the material to be worked to make sure
that all foreign objects have been removed, e.g.
nails, screws, etc..
♦ Ensure that the ventilation slits are not covered.
to select the desired
. The working
and illuminates the work-
.
and lock it in this
.
and release it
PFS 710 C2