Kuppersbusch DEF6800.0 Instrucciones De Uso página 20

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 9
special attention to the grids. Afterwards, dry it
using a lint-free cloth.
Note:
 Never use metallic scouring pads or
abrasive products that could damage the
surface.
 Do not use scrapers with metallic surfaces
such as knives, scissors etc.
Activated charcoal filter
 To install the charcoal filter, the motor
anchorage is made to coincide with the
Dimensions:
Width = 600/ 900 mm
Depth = 300 mm
Height = 183/273 mm
To fix the cooker hood please choose one of
the following options:
a) Fixing to the upper part of the furniture:
Figure 4 must be used where the position
of the holes is indicated.
b) To the internal side of the furniture:
When the body hood fits within the
furniture, fasten with two screws on each
side from the inside of the body hood,
using their side holes.
The lower part of the extractor must be
located at a minimum height of 60 cm above
the hob for electric cookers and 65 cm for gas
cookers. If the instructions of a gas cooker
indicate a greater distance these must be
observed.
20
anchor points of the activated charcoal
filter and turn it clockwise.
 The carbon filter lasts from three to six
months
depending
conditions of use.
 The activated carbon filter can neither be
washed nor regenerated. Once it is
exhausted, it must be changed.
 To replace exhausted filters with new ones,
withdraw the old one in the reverse order
to that of installation.
Electrical characteristics:
REFER TO RATING PLATE
To achieve optimum performance the length of
the outlet hose should not exceed 4 meters, or
include more than two 90º angles (elbows).
Although
venting
recommended, activated carbon filters may be
used, which allow the gas to be returned to
the kitchen through the outlet pipe.
If you wish to exchange the front for one
matching the kitchen units, follow the following
instructions (Fig. 3):
 Withdraw the movable group.
 Remove the screws (T) that support the
front.
 Install the new front fixing it with the same
screws that held the old one.
on
the
particular
to
the
outside
is

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Def9800.0

Tabla de contenido