3
Select "Dial", or press the CONNECT/DISCONNECT (
on the Remote Commander to call the remote party.
Use the V, v, B or b button on the Remote Commander to select "Dial", then
press the PUSH ENTER button. Or press the CONNECT/DISCONNECT
(
)
/
button on the Remote Commander and the system begins dialing
and "Dialing" appears.
When the system connects to the remote system, the "Meeting starts!" message
appears and the following screen is displayed.
Local picture
If the following dialog is displayed after Step 3
More options
The above dialog appears when "More Options Enable" in the Dial Setup menu
is set to "On".
Dial?
Dial
Cancel
Cancel a call.
Call a remote party.
Change the line settings.
/
) button
Remote picture
Calling a Remote Party
9
GB