Audio Component Hookups; Speaker System Hookups - Sony TA-VE700 Manual De Instrucciones

Audio Component Hookups

Overview
This section describes how to connect your audio
components to the amplifier.
For specific locations of the jacks, see the illustration
below.
y
TAPE/MD
PHONO TUNER CD
What cords will I need?
Audio cords (not supplied) (1 for each CD player and Tuner
(turntable, if necessary); 2 for tape deck, or MD deck)
White (L)
Red (R)
Hookups
The arrow ç indicates signal flow.
CD player
Amplifier
IN
L
R
CD
Tuner
Amplifier
IN
L
R
TUNER
Tape/MD deck
Amplifier
REC OUT IN
L
R
TAPE/MD
Turntable
Amplifier
IN
L
R
PHONO
White (L)
Red (R)
CD player
OUTPUT
LINE
L
R
Tuner
OUTPUT
LINE
L
R
TAPE/MD
OUTPUT INPUT
LINE LINE
L
R
Turntable
• If your turntable has an earth lead
To prevent hum, connect the earth lead to the y ground
terminal on the amplifier.
Where do I go next?
Go on to the next section to connect the speakers.

Speaker System Hookups

Overview
This section describes how to connect your speakers to
the amplifier. Although front (left and right) speakers
are required, centre, rear speakers, and active woofer
are optional. Adding centre and rear speakers will
enhance the surround effects. Connecting an active
woofer will increase bass response.
For specific locations of the terminals, see the
illustration below.
MIX AUDIO OUT FRONT SPEAKERS A
SURROUND
SPEAKERS REAR
For optimum surround sound effect, place your
speakers as shown below.
45°
Front speaker
What cords will I need?
• Speaker cord (not supplied) (1 for each speaker)
(+)
(–)
Twist the stripped ends of the cord about 15 mm (2/3 inch).
Be sure to match the speaker cord to the appropriate
terminal on the components: + to + and – to –. If the cords
are reversed, the sound will be distorted and will lack bass.
• Monaural audio cord (not supplied) (1 for an active
woofer)
Black
Getting Started
SURROUND
SPEAKERS CENTER
Rear speaker
60 - 90 cm
(+)
(–)
Black
(continued) 5 EN