Tv/Vcr Hookups - Sony TA-VE700 Manual De Instrucciones

Getting Started
Hookups
Front speakers
Front speaker
(R)
} ]
To connect the speaker cords
Rear and centre speakers
Rear speaker
(R)
} ]
Active woofer
Amplifier
MIX
AUDIO
OUT
If you have an additional front speaker system
Connect them to the FRONT SPEAKERS B terminals.
If your TV monitor uses separate speakers
You can connect one of them to the SURROUND
SPEAKERS CENTER terminals for use with Dolby Pro
Logic Surround Sound (see page 13).
Selecting the speaker system
If you connect only one set of front speakers, set the
SPEAKERS selector on the front panel to A. If you
connect two sets of front speakers, see the following:
6 EN
Front speaker
Amplifier
FRONT SPEAKERS
IMPEDANCE USE 4-16 Ω
A A
R L
] }
≥
] }
Rear speaker
Amplifier Centre speaker
SURROUND SPEAKERS
R REAR L CENTER
} ]
R L
Ω
8-16Ω IMPEDANCE USE 4-16Ω
Active woofer
INPUT
To drive
Speaker system A (connected
to the FRONT SPEAKERS A
terminals)
(L)
Speaker system B (connected
to the FRONT SPEAKERS B
terminals)
} ]
Both speaker systems A and
B (parallel connection)
*Do not use A+B with SOUND FIELD set to ON.
Where do I go next?
To complete your system, go to "AC Hookups" on page 7. If
you want to connect video components to enjoy surround
sound when watching TV programmes or video tapes, go on
to the next section.

TV/VCR Hookups

Overview
(L)
This section describes how to connect video
components to the amplifier. For specific locations of
} ]
the jacks, see the illustration below.
MONITOR TV/LD
What cables will I need?
• Audio/video cable (not supplied) (1 for TV or LD player;
2 for each VCR)
Yellow
White (L)
Red (R)
• Video cable (not supplied) (1 for a TV monitor)
Yellow
If you want to watch higher quality video images
You can use an S-VIDEO cable (not supplied).
• S-VIDEO cable (not supplied)
Set SPEAKERS selector to
A
B
A+B*
VIDEO 2
VIDEO 1
Yellow
White (L)
Red (R)
Yellow