Cleaning The Shaver - Panasonic ES-RT87 Instrucciones De Operación

Reading lamps when using
During use
All lamps disappear while
using.
• You can shave 2 to 3 times after the battery capacity lamp
blinks. (This will differ depending on usage.)
• A full charge will supply enough power for approx. 18 shaves
of 3 minutes each. (This will differ depending on usage.)

Cleaning the shaver

Cleaning using the self-cleaning recharger
►Preparing the self-cleaning recharger
Remove the shaver and the appliance plug from the self‑
cleaning recharger.
1
1
Place the self-cleaning recharger [B] on a hard,
flat surface.
• When the self‑cleaning recharger is lifted, or on the soft
surface such as carpets, the lock release lever will not fit
in the recharger properly. In that case, the cleaning
liquid unit cannot be removed.
When the battery capacity is
low
The battery capacity lamp
blinks for 5 seconds when
the power switch is pressed.
2
2
Press the cleaning
liquid unit removal
button [BB] (1)
and remove the
cleaning liquid unit
[B] (2).
3
3
Wash away the old cleaning liquid and beard
trimmings and then rinse the cleaning liquid unit.
• After washing, be sure to attach the cleaning liquid filter.
4
4
Pour tap water (1) and
detergent (2) into the
cleaning liquid unit.
• Do not let the water rise
above the maximum water
line. This may cause the
cleaning liquid to spill.
5
5
Attach the cleaning liquid unit.
• Immediately wipe up any cleaning
liquid that has been spilt.
Be careful not to drop cleaning liquid
onto leather products or wooden
floors as it may cause discoloration.
6
6
Press the top of the self-
cleaning recharger down and
securely attach until it clicks.

 

15