Stihl MH 610 Manual De Instrucciones página 9

6 Assembling the Cultivator
► Push hoes (1) onto drive shaft (2) so the bores
align.
► Push folding retainers (3) through the bores in
drive shaft (2) and close the securing clips.
Hoes (1) are secured.
6.1.2 Removing the Hoes
► Stop the engine.
► Pull out the folding retainers.
► Remove the hoes.
► Push the folding retainers through the bores in
the drive shaft.
The folding retainers are kept in place.
6.2 Attaching and Removing the
Running Wheels
6.2.1 Attaching the Running Wheels
► Stop the engine.
► Open the valve on the running wheels and
allow air to escape.
► Remove bolts (1) together with washers (2),
spring washers (3) and nuts (4).
► Remove rim halves (5) from rubber tyre (6).
► Place rim halves (5) and axle mount (7) on
rubber tyre (6) so the bores align.
► Insert bolts (1).
► Place washers (2) and spring washers (3) on
bolts (1).
► Screw on nuts (4) and tighten.
► Push running wheels (1) onto drive shaft (2)
so the bores align.
0478-404-9902-B
► Push folding retainers (3) through the bores in
drive shaft (2) and close the securing clips.
Running wheels (1) are secured.
6.2.2 Removing the Running Wheels
► Stop the engine.
► Pull out the folding retainers.
► Remove the running wheels.
► Push the folding retainers through the bores in
the drive shaft.
The folding retainers are kept in place.
6.3 Attaching the Blade Spur
► Fit blade spur (1) into adapter (2) from below
so the bore on adapter (2) aligns with the low‐
ermost bore on blade spur (1).
► Insert pin (3).
► Push retaining pin (4) through the bore in
pin (3).
► Screw in screw (5) and tighten firmly.
The blade spur is secured.
6.4 Attaching the Front Wheel
► Detach retaining pin (1) and remove pin (2).
► Pull out retaining pin (3), unscrew castellated
nut (4), remove washer (5) and bolt (6).
English
9