Cleaning And Maintenance; Lubricate The Brake System; Defects And Malfunctions; Transport And Storage - Tunturi FitRace 40 HR Manual Del Usuario

Workout target setting
- Press MODE/ RESET key to cycle between the functions of: TIME,
DISTANCE, CALORIES & PULSE.
- Use SET key to set target value for selected setting and press
MODE/ RESET key for confirmation, and open first next target
setting�
- Use SET key to set target value for next selected setting and press
MODE/ RESET key for confirmation, and open first next target
setting, and so on for all targets�
- When leaving a target setting 0, it will not be seen as a target�
- Start pedaling to start the workout at any time, and non set target
values will count up�
- If a target is set for a specific value, that value will countdown, till
target is reached�
- When target is reached, an alarm sound will appear shortly, and
that specific parameter value will continue to count up when keep
working out�
When exceed the set PULSE target, the alarm will maintian untill
the PULSE reading is under target range again�

Cleaning and maintenance

The equipment requires very little maintenance, please follow up on
below instructions� The equipment does not require recalibration
when it is assembled, used and serviced according to the instructions�
⚠ WARNING
• Do not use solvents to clean the equipment�
• Clean the equipment with a soft, absorbent cloth after each use�
• Regularly check that all screws and nuts
are tight�
• If necessary, lubricate the joints�

Lubricate the brake system

Lubrication is a highly important service activity for the Sprinter bike�
Lubrication is absolutely essential when:
- The friction of the brake system increases noticeably�
Increased friction is indicated by jerky movement in higher
resistance levels�
- The brake pads become noisier over time�
The need for re-lubrication depends to a great extent on the
resistance settings and hours of use� Also the environment humidity
is a factor�
We recommend you apply one drop of a silicon-based lubrication
product only when you feel there is a need to lubricate�
⚠ WARNING
• Never apply more than one drop of oil (silicone) each time, to
avoid the brake system will be lubricated too much and therefore
loses tension build-up�

Defects and malfunctions

Despite continuous quality control, defects and malfunctions caused
by individual parts can occur in the equipment� In most cases, it will
be sufficient to replace the defective part�
- If the equipment does not function properly, immediately contact
the dealer�
- Provide the model number and the serial number of the equipment
to the dealer� State the nature of the problem, conditions of use
and purchase date�
Trouble shooting:
- When the display of LCD is dim, it means the batteries need to be
changed�
- If there is no signal when you pedal, please check if the cable is
well connected�
‼ NOTE
• When stop training for 4 minutes, the main screen will be off�
• If the computer displays abnormally, please re-install the
batteries and try again�
Shaky or unstable feeling during use
If the machine feels unstable or unstable during operation, it is
advisable to adjust the support feet to bring the frame to the correct
height. Read the instructions in this manual in section: "Use"

Transport and storage

⚠ WARNING
• Carry and move the equipment with at least two persons�
- Remain standing in front of the equipment on each side and take
a sturdy grip at the handlebars� Tilt the front of the equipment
so as to lift the rear of the equipment on the wheels� Move the
equipment and carefully put the equipment down� Place the
equipment on a protective base to prevent damage to the floor
surface�
- Move the equipment carefully over uneven surfaces� Do not move
the equipment upstairs using the wheels, but carry the equipment
by the handlebars�
- Store the equipment in a dry place with as little temperature
variation as possible�

Additional information

Packaging disposal
Government guidelines ask that we reduce the amount of waste
material disposed of in land fill sites� We therefore ask that you
dispose of all packaging waste responsibly at public recycling centres�
End of life disposal
We at Tunturi hope you enjoy many years of enjoyable use from your
fitness trainer� However, a time will come when your fitness trainer will
come to the end of its useful life� Under 'European WEEE Legislation
you are responsible for the appropriate disposal of your fitness trainer
to a recognised public collection facility�

Warranty

Tunturi purchaser's warranty
Warranty terms
The consumer is entitled to the applicable legal rights stated in
the national legislation concerning the commerce of consumer
goods� This warranty does not restrict these rights� The Purchaser's
Warranty is only valid if the item is used in an environment approved
by Tunturi New Fitness BV, and is maintained as instructed for that
particular equipment� The product-specific approved environment
and maintenance instructions are stated in the "user manual" of the
product. The "user manual" can be downloaded from our website.
http://manuals�tunturi�com
1 7
GB