Cleaning And Maintenance; Defects And Malfunctions; Transport And Storage; Additional Information - Tunturi StarFit F100 Manual Del Usuario

English
F1 Outstanding
F2.x Excellent
F3.x Good
F4.x Fair
F5.x Below average
F6 Poor
Body Fat
- Press the "User data" key to enter body parameters setting mode.
-
- Press "Body Fat" button to start the body measurement.
During measuring, users have to hold both hands on the hand
grips. LCD display "-" "- -" "- - -" "- - - -" for 8 seconds until
computer finish measuring.
- LCD will display BMI , FAT %. and BMR.
‼ NOTE
• This data is a rough guide as a reference, for comparison
of different measurement intervals which cannot be used in
medical treatment
BMI Reading:
• 5 ~10: Extremly underweight
• 11~18: Underweight
• 19~24: Healthy
• 25~29: Overweight.
• 30~39: Obese
• 40~ +: Extremely obese
FAT % Reading
 Under
Fat %
age 20-39 < 21%
Age 40- < 23%
59
Age 60- < 24%
79
 Under
Fat %
age 20-39 < 8%
Age 40- < 11%
59
Age 60- < 13%
79
BMR reading (Basal Metabolic Rate)
The BMR reading shows the calculated amount of calories your body
needs on a daily basis to function. This is not account activities, but
just the energy required to sustain a heartbeat, breath and keep
normal body temperature.
Body fat mode error codes
- ERR
There is no heart rate signal input detected.
- Occurs when FAT% and BMI result is below 5 or exceeds 50.
Trouble shooting:
- If there is no signal when you pedal, please check if the cable is
well connected.
‼ NOTE
• When exceeding the speed of 99.9 Km/H the dislay will show
"E".
Ideal Fat% Over Fat% Obese
Fat%
21~33% 34~39% >39%
23~34% 35~40% >41%
24~35% 36~42% >42%
Ideal Fat% Over Fat% Obese
Fat%
8~19% 20~25% >25%
11~21% 22~28% >28%
13~35% 25~30% >30%
• If the computer displays abnormally, please re-install the
transformer and try again.

Cleaning and maintenance

The equipment does not require special maintenance. The
equipment does not require recalibration when it is assembled, used
and serviced according to the instructions.
⚠ WARNING
• Do not use solvents to clean the equipment.
• Clean the equipment with a soft, absorbent cloth after each use.
• Regularly check that all screws and nuts
are tight.
• If necessary, lubricate the joints.

Defects and malfunctions

Despite continuous quality control, defects and malfunctions caused
by individual parts can occur in the equipment. In most cases, it will
be sufficient to replace the defective part.
- If the equipment does not function properly, immediately contact
the dealer.
- Provide the model number and the serial number of the equipment
to the dealer. State the nature of the problem, conditions of use
and purchase date.
Trouble shooting:
- When the display of LCD is dim, it means the batteries need to be
changed.
- If there is no signal when you pedal, please check if the cable is
well connected.
‼ NOTE
• When stop training for 4 minutes, the main screen will be off.
• If the computer displays abnormally, please re-install the
batteries and try again.

Transport and storage

⚠ WARNING
• Carry and move the equipment with at least two persons.
• Move the equipment and carefully put the equipment down.
Place the equipment on a protective base to prevent damage to
the floor surface.
• Move the equipment carefully over uneven surfaces. Do not
move the equipment upstairs using the wheels, but carry the
equipment by the handlebars.
• Store the equipment in a dry place with as little temperature
variation as possible.

Additional information

Packaging disposal
Government guidelines ask that we reduce the amount of waste
material disposed of in land fill sites. We therefore ask that you
dispose of all packaging waste responsibly at public recycling centres.
End of life disposal
We at Tunturi hope you enjoy many years of enjoyable use from
your fitness trainer. However, a Time will come when your fitness
trainer will come to the end of its useful life. Under 'European WEEE
Legislation you are responsible for the appropriate disposal of your
fitness trainer to a recognised public collection facility.
1 8