Cleaning And Maintenance; Defects And Malfunctions; Transport And Storage - Tunturi Pure UB 6.0 Manual De Instrucciones

1. Locate the C/F switch on the rear of the console.
2. Move the C/F switch to "C" to use Celsius (°̊ C ) as the default system of
measurement.
3. Move the C/F switch to "F" to use Fahrenheit (°̊ F ) as the default system of
measurement.

Cleaning and maintenance

Defects and malfunctions

Despite continuous quality control, defects and malfunctions caused by individual
parts can occur in the equipment. In most cases, it will be sufficient to replace the
defective part.
1. If the equipment does not function properly, immediately contact the dealer.
2. Provide the model number and the serial number of the equipment to the dealer.
State the nature of the problem, conditions of use and purchase date.

Transport and storage

WARNING
– Carry and move the equipment with at least two persons.
1. Remain standing in front of the equipment on each side and take a sturdy grip at
the handlebars. Lift the front of the equipment so as to lift the rear of the
equipment on the wheels. Move the equipment and carefully put the equipment
down. Place the equipment on a protective base to prevent damage to the floor
surface.
2. Move the equipment carefully over uneven surfaces. Do not move the equipment
upstairs using the wheels, but carry the equipment by the handlebars.
3. Store the equipment in a dry place with as little temperature variation as
possible.
UB 6.0
EN
27