Important Safety Notes - Walimex Pro Light Shooter 360 TTL Manual De Instrucciones

2. Important safety notes

WARNING
Danger of electric shock, burn hazard
Please note that the device is still connected to the supply voltage when
it is switched off. The device is supplied with residual voltage even after a
complete discharge.
■ Switch off the device when it is not in use.
■ Switch off your device before assembly and maintenance and dis-
connect from power supply by setting the on/off switch to 0 (OFF) and
by unplugging the power cord.
■ Discharge your device before maintenance measures.
■ Protect your device against accidental power-on.
■ Do not reach into a connection socket or an opening on the device.
WARNING
Danger of electric shock, fire due to short circuit
A short circuit could be caused by defective cables and due to moisture or
wetness. A short circuit can heat up the conductors resulting in the melting
of their insulation or of the conductors themselves. This could lead to fire.
■ Please use exclusively the original cables, which are provided with the
device. They are tuned for your device and guarantee the necessary
safety for you and your device.
■ Do not operate the device with wet hands or feet.
■ Clean the device exclusively as described in this instruction manual.
■ Ensure that cables and conductors are not damaged. Damage could
be caused due to heat impact, chemical influence or due to mechani-
cal impacts such as rubbing, bending, tearing, rolling over, or nibbling
animals.
■ Prevent your device from falling.
In the case of it falling, please have an electrician check the device
before switching it on again.
22
■ If your device is damaged or defective or if you notice a burning smell:
Disconnect the power supply immediately by unplugging the power cord
and setting the on/off switch to 0 (OFF). Never operate your device with
a damaged casing or a damaged power cord. Do not open the device.
Never repair the device on your own. Have the device repaired exclusi-
vely by an electrician.
■ Please follow this instruction manual for maintaining your device.
■ Please only use spare parts which are conform to the required specifi-
cations. See Technical specifications.
WARNING
Danger of fire by overheating
The device itself and easily inflammable materials in close distance can
catch fire.
■ Do not leave the device unsupervised while it is being charged.
■ Remove easily inflammable materials which are in close distance to the
device.
■ Please only use spare parts which are conform to the required specifi-
cations. See Technical specifications.
23