Use Of Rinse Aid - Electrolux ESL 68060 Manual De Instrucciones

8 electrolux
4. Replace the cap making sure that there
is no trace of salt on the screw thread or
on the gasket.
5. Replace the cap tightly turning it clock-
wise until it stops with a click.

Use of rinse aid

Warning! Only use branded rinse aid for
dishwashers.
Never fill the rinse aid dispenser with any
other substances (e.g. dishwasher
cleaning agent, liquid detergent). This
would damage the appliance.
Rinse aid ensures thorough rinsing, and
spot and streak free drying.
Rinse aid is automatically added during
the last rinse.
1. Open the container by pressing the re-
lease button (A).
Do not worry if water overflows from the
unit when filling with salt, this is quite
normal.
The salt container will require topping up pe-
riodically.
The display shows a message when the salt
container is empty.
This occurs only at the start and at the end
of the washing programme; during the run-
ning of the programme the indication for salt
refilling is not active.
The refilling salt message can remain
visible for a few hours after the salt has
been replenished, assuming the appli-
ance remains switched on. If you are us-
ing salt that takes longer to dissolve then
this can take longer. The operation of the
appliance is not affected.
2. Add the rinse aid in the container. The
maximum level for filling is indicated by
"max".
The dispenser holds about 110 ml of rinse
aid, which is sufficient for between 16 and
40 washing cycles, depending upon the
dosage setting.
3. Ensure that the lid is closed after every
refill.
Clean up any rinse aid spilt during filling
with an absorbent cloth to avoid excess
foaming during the next wash.