Elevated Base Frame Installation - Alliance Laundry Systems HC18 Instalación/Mantenimiento

Elevated Base Frame Installation

(2-Speed Models Only)
Note: The 3-speed and variable-speed
models should not be installed on elevated
base frames.
Factory-built elevated steel base frames are
designed to meet the specifications of the
2-speed model washer-extractor. See
Figure 21.
Figure 21
Use the following instructions and Figures
22 through 26 as a step-by-step guide to
installation of the elevated base frame.
F232062
1. Verify that the floor is 3500 psi minimum
reinforced concrete embedded in clean,
compacted fill dirt. The floor must be at
least 4 inches (102 mm) thick.
2. Use the elevated base frame as a template
by positioning the frame in the desired
location and marking the pre-drilled
mounting holes on the floor. See
Figure 22.
3. Adjust the drill depth gauge to match the
length of the J-bolt, minus 1-1/2 inches
(38 mm). See Figure 23.
H035I
Installation
Figure 22
Figure 23
H025I
H026I
33