Kohler 3600A Serie Guia De Instalacion página 11

13. Install the Door Panel
Insert the pivot pin into the top bracket hole and lift the door panel and position the door handle
magnet toward the strike jamb magnet.
NOTE: Perform the remaining steps from inside the shower.
Place the bottom door panel block hole (hole farthest from the door handle) over the bottom bracket
pin. Do not place the side frame of the door panel over the pin.
Pull the top bracket pivot pin up and align the top block hole (hole farthest from the door handle)
with the top bracket hole.
Insert the pin through the bracket hole into the block hole.
Loosen the block screws and slowly close the door panel.
Slide the blocks in the top and bottom frames into a position that allows the door to close with
approximately 1/4" (6 mm) clearance from the edge of the strike jamb.
Make sure that the bottom of the door panel does not rub on the bottom track seal. Tighten the
block screws.
For final adjustments, loosen the strike expander jamb screws.
Align the strike expander with the door panel handle frame. There should be a 1/4" (6 mm) gap at
the top and bottom of the door panel.
Tighten the strike expander jamb screws.
Sterling
Bracket
Hole
Inside of
Shower
Block Hole
Pivot Pin
11
Pivot
Pin
Top
Bracket
Block
Hole
Do Not Place
Pivot Pin in
This Area
Bottom
Bracket
1034022-2-B