Megger VF6 EX Guia De Inicio Rapido página 5

Medium Voltage Mode (100 to 1000V AC): Place the tip of the VF6 EX near an AC
6.
voltage. If the VF6 EX detects voltage within the defined detection range the green LED
will turn off, the red LED will turn on, the sounder will beep rapidly and the detector will
vibrate constantly.
NOTE: The detector cannot determine the actual voltage. The voltage level where the detector
switches from the low to medium voltage mode is affected by insulation type and thickness,
distance from the voltage source, and other factors.
Low Battery Indication: Replace the batteries if the green LED does not turn on. When
7.
the detector is on and the batteries are too low for reliable operation, the sounder will
beep three times and the green LED will turn off indicating the detector Is not operation-
al. Replace the batteries to restore operation.
Auto Power Off: To conserve battery life the detector will automatically turn off after
8.
approximately 5 minutes of inactivity. When powering down the detector will beep twice,
vibrate twice and the green LED will turn off.
9. Torch: Momentarily press the torch
battery life, the torch will automatically turn off after approximately 5 minutes.
NOTE: If the battery voltage is too low to operate the torch, the detector will indicate this
condition by beeping three times and the torch will turn off. The voltage detector has its own
low battery threshold and may remain operational. Refer to Verify Operation (Step 4) in this
guide before using detector.
button to turn the torch on or off. To conserve