Kohler K–8135 Guia De Instalacion página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Anchor Installation
NOTE: You may need to disassemble some of the accessories. Some
accessories will be packed with the wall plate installed in the post.
Loosen the setscrew and remove the wall plate if needed.
Press and hold the legs of a wall anchor (provided) together and
insert the wall anchor legs into the hole. Insert all wall anchors
into the pre-drilled mounting holes.
With a hammer, carefully tap each wall anchor until they are
flush with the finished surface.
If the wall anchor was inserted into a space between the studs, it
will be necessary to spread the wall anchor legs.
Repeat for all wall anchors inserted between studs.
Ensure that the wall anchors are flush with the finished surface.
4. Install the Wall Plate
NOTE: If you are installing the K-8144 mirror, go to the "Install the
Mirror" section.
Orient the wall plate with the large slotted mounting hole on the
bottom and the smaller hole over the higher anchor.
Secure the wall plate with the supplied panhead screws.
Repeat for each wall plate if multiple wall plates are needed.
Kohler Co.
5
1020821-2-A

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

K–8136K–8137K–8141K–8142K–8144

Tabla de contenido