Fault - Possible Cause - Solution - Saeco MAGIC CAPPUCINO COMBI SILVER Instrucciones De Uso

Fault
The machine does not Machine is not connected to the
turn on mains.
The pump is very noisy. No water in the tank.
The coffee is too cold. The temperature ready LED (5)
was switched off when the switch
(4) was pressed.
The filter-holder is not inserted for
preheating (chap. 5).
Cold cups
Milk froth does not form. The milk is not suitable.
The coffee is dispensed Too little coffee in the filter-holder. Add coffee (chap.5).
too fast, the cream does
The blend is too coarse.
not form.
Coffee is old or not suitable.
Coffee is not dispensed or No water.
dispensed only in drips.
The blend is too fine.
Coffee pressed in the filter-holder. Shake the ground coffee.
Too much coffee in the filter-holder. Reduce the quantity of coffee in the filter-
"Hot water/Steam" knob open (7). Close the knob (7).
Calcified machine.
The filter in the filter-holder is
clogged.
Pods not suitable.
Coffee is dispensed from The filter-holder is incorrectly
the edges inserted in the brew unit.
Upper edge of the filter-holder is
dirty.
The gasket of the boiler is dirty
or worn.
Too much coffee in the filter-
holder.
Pod wrongly inserted.
Please contact the service centre for any faults not covered in the above table or when the suggested
solutions do not solve the problem.
Possible cause Solution
Connect the machine to the mains.
Refill with water. (par 4.4).
Wait until the LED lights up.
Preheat the filter-holder.
Preheat the cups on the warming plate
Check fat content.
Use a different blend (chap.6).
Use a different blend (chap.6).
Refill with water. (par 4.4).
Use a different blend (chap.6).
holder.
Descale the machine (chap.11).
Clean the filter (chap. 10).
Change type of pod.
Insert the filter-holder correctly (chap. 5).
Clean the rim of the filter-holder.
Clean or replace the gasket.
Reduce the quantity of coffee using the
doser.
Insert the pod correctly.
ENGLISH
• 31 •