Important - SPALDING M7A1021 Manual Del Usuario

I
FILL ASSEMBLED UNIT FOR USE
TO FILL WITH WATER:
1. Roll the completed assembly to desired
location.
2. Tighten the base cap (23) and base cap
gasket (45) securely into place.
3. Fill the base with water (approx. 31 gallons /
117 Liters).
4. Push in the cap (24) securely.
ADD AT LEAST TWO GALLONS (7.6 LITERS) OF NON-TOXIC ANTIFREEZE IN SUB-FREEZING CLIMATES.
CHECK WATER LEVEL BEFORE EACH USE!
TO FILL WITH SAND:
1. Roll the completed assembly to desired
location.
2. Carefully tip the system forward.
3. Fill the base with sand (approx. 400 lbs. /
181 kg).
4. When the base has the appropriate
amount of ballast, tighten the base cap
(23) and base cap gasket (45) securely
into place.
5. Push in the cap (24) securly.
6. Carefully upright the system.
No matter which hole is used for filling, BOTH caps MUST be tightened COMPLETELY and SECURELY to prevent leakage.
IF USING SAND: ANTIFREEZE IS NOT REQUIRED.
CAUTION

IMPORTANT

NOTE
27
Fill Assembled Unit for Use
#23
#45
#24
#24
#45
#23