B.Braun Aesculap VetCare GT 405 Traducción Del Manual Original página 18

Cleaning the blade set
Damage to the blade set caused by its
disassembling in its individual parts!
Never disassemble the blade set. Once
WARNING
disassembled it cannot be reassembled.
If used regularly, the blade set 4 should be thoroughly
cleaned once a day.
18
Switch the appliance off.
Push the entire blade set off the
front of the trimmer.
Use the cleaning brush 13 to re-
move any hairs.
Slightly push apart the upper
and lower parts of the blade set
(see illustration) and use the
cleaning brush to remove any
hairs between them.
Oiling the blade set
The blade set 4 must be oiled regularly - preferably dai-
ly.
Remove the blade set.
Lubricate the areas where there
is contact between the upper
and lower parts of the blade set
(see illustration).
Run the trimmer for about 20 seconds to ensure that
the oil is properly distributed. - You can carry on
working if you want to.
Replacing the blade set
The blade set is subject to wear. Even if you look after the
appliance properly, the cutting performance will deteri-
orate. Replace the blade set when it is worn. The blade
set can be ordered separately as a spare part from
Aesculap Customer Service (see addresses at the end of
these instructions).