Hach NA5600 sc Instrucciones Para El Usuario página 3

Table of Contents
1 Table of contents on page 3
2 Specifications on page 3
3 General information
4 Installation on page 7
Section 1 Table of contents
Specifications on page 3
Safety information on page 4
Product overview on page 5
Product components
Items to collect on page 7
Installation on page 7
Circuit diagrams for HART communication
on page 15
Section 2 Specifications
Specifications are subject to change without notice.
Specification
Operating temperature
Storage temperature
Wiring
Power consumption
Minimum current
Maximum current
Linearity
HART receive impedance
Internal module loop power
Lift-off voltage
External loop power over temperature 30 VDC maximum
1
Use shielded wire for long distances where ambient electrical noise will have an effect on
communication.
2
For distances longer than 1524 m (5000 ft), use 0.518 mm
on page 4
on page 5
Details
–20 to 60 °C (–4 to 140 °F); 95% relative humidity, non-
condensing
–20 to 70 °C (–4 to 158 °F); 95% relative humidity, non-
condensing
Wire gauge: 0.205 to 1.309 mm
pair wire with an insulation rating of 300 VAC or higher
2 W maximum
3 mA
23 mA
± 0.05% of span
Rx > 200 KΩ; Cx = 4 pF
15 VDC
13.3 VDC
5 Configuration on page 17
6 Diagnostics on page 18
7 Troubleshooting on page 19
Circuit diagrams for non-HART communication
on page 16
Install the latest firmware
Install the HART device description files
on page 17
Configuration on page 17
Diagnostics on page 18
Troubleshooting on page 19
2
2
(20 AWG) wire minimum.
on page 17
(24 to 16 AWG), twisted-
1, 2
English 3