Saeco XSMALL PLUS V2 ANT SIL SUP033R Instrucciones De Uso página 26

CONTROL PANEL LIGHTS
Light Signals Causes
The machine has reached the right temperature and
is now ready:
Steady on - For coff ee brewing;
- For hot water dispensing;
- For steam dispensing
The machine is warming up to brew coffee and
Slowly fl ashing
dispense hot water or steam.
Machine is overheating. Coff ee may not be brewed.
Quickly fl ashing
Indicates that the machine is programming the
amount of coff ee to brew (see section "Adjusting the
Slowly fl ashing
Brewed Coff ee").
The machine is brewing a double coff ee
Steady on
Low water level.
Steady on
The coff ee bean hopper is empty.
The dregdrawer is full
Steady on
The water circuit is empty.
Quickly fl ashing
Brew group not inserted. Dregdrawer not inserted.
Service door open. Control dial is not in correct position.
Slowly fl ashing
The machine is performing the rinse/self-cleaning
cycle
+
Blinking in counter-
clockwise direction (cyclical)
A fault has occurred in the brew group.
Flashing
alternately
A fault has occurred in the machine and hot water,
steam or coff ee cannot be dispensed.
+
Flashing
simultaneously
• 26 •
Solutions
The water must be drained into a container by turning the
selector switch clockwise to the
ready temperature light
dispensing water.
Fill the water tank with fresh drinking water. After refi lling the water
tank, the indicator light turns off .
Fill the hopper with coff ee beans and start the procedure again.
With the machine turned on, empty the dregdrawer. The dregdrawer
must be emptied after every 8 coff ee cycles. If the dregdrawer is
emptied with the machine turned off , or when the indicator light
is not illuminated, the count of coff ee cycles is not reset. For this
reason, the indicator light to empty the dregdrawer may illuminate
even when it is not full.
Fill the tank with fresh drinking water and prime the water circuit as
described in Section "Using the Machine for the First Time".
Make sure that all components have been correctly inserted and
closed. The blinking red light will now turn off .
The machine ends the cycle automatically.
You can interrupt the cycle by pressing either coff ee button.
Try again to brew another coff ee.
Turn the machine off . After 30-seconds, turn it back on.
Try this 2 or 3 times.
If the machine does NOT start, contact an authorized service center.
" "
position until the green
" "
stays constantly on. After that, stop