Switch From Bike 1 To Bike; Service Interval Display - VDO X Serie Manual De Instrucciones

GB SLO PL JP
ODOMETER/ODO BIKE 1
(use to go to setting for
BIKE 2). Confirm with M .
ODO BIKE 1 ...SET DISTANCE/
CONTINUE.
You can set the flashing digits
using .

5.5 Switch from bike 1 to bike 2

Your VDO computer can be used on two bikes.
If you switch from bike 1 to bike 2, you must set the
computer to the bike being used before the ride.
Using go to SETTINGS/
SELECT. Confirm with M .
You are now in setting mode
(pressing C for 3 seconds gets
you back to function mode).
Using go to BIKE/SELECT
Confirm with M .
BIKE 1 (use to switch to
bike 2). Confirm with M .
14 X2
To access the next digit, confirm with M .
Repeat the steps until the last digit on
the right is flashing. Confirm with M .
ODO BIKE 1/SET OK? Confirm with M .
The display confirms ODO BIKE 1/SET DONE.
Automatic return to SETTINGS/SELECT.
BIKE 1 /SELECT OK? Confirm with M .
The display confirms BIKE/SE-
LECT DONE
Automatic return to SETTINGS/
SELECT
The selected bike 1 or 2) is shown on the display
bottom left. ( )
ATTENTION, important note: When switching
from bike 1 to 2 or vice versa, the data for day's
tripdistance, ride time, average speed and max.
speed for the last trip are set to zero.
VDO CYCLECOMPUTING

5.6 Service interval display

The VDO service interval display reminds you to
have your bike checked in the workshop.
You can switch the service interval ON or OFF.
You can set separate service intervals for 2 bikes
When the set service interval distance has been
reached:
The -symbol flashes on the display.
B
The information line displays
B
BIKE SERVICE/BIKE 1
You should now either carry out the
recommended bike check yourself or
have the bike checked by your dealer.
Press any button. The text BIKE SERVICE
disappears again. After another 50 km
the also disappears. You can also switch
off the flashing -symbol.
To do so, enter the service interval again.
How to set the service interval:
Using go to SETTINGS/
SELECT. Confirm with M .
You are now in setting mode
(pressing C for 3 seconds gets
you back to function mode).
Using go to BIKE SERVICE/
SET. Confirm with M .
www.vdocyclecomputing.com
JP PL SLO
BIKE SERVICE/ON (switch to OFF
using ). Confirm with
BIKE SERVICE/BIKE 1
(use to switch to bike 2)
Confirm with .
M
BIKE 1 ...SET DISTANCE/
CONTINUE. You can set the
flashing digits using .
To access the next digit,
confirm with M .
Repeat the steps until the last digit on the right
is flashing. Confirm with M .
BIKE 1/SET OK? Confirm with M .
The display confirms: BIKE SERVICE/SET DONE.
Automatic return to SETTINGS/SELECT.
X2
GB
M .
15