Dust Extraction; Working With The Power Tool - Festool PLANEX easy LHS-E 225 EQ Manual De Instrucciones

7
WARNING
Risk of injury
Do not hold the power tool by the sanding head.

Hold the power tool with both hands using the

gripping surfaces [1-10].
To switch on the power tool, see Section Com-

missioning.
Carefully place the sanding head onto the sand-

ing surface.
Perform the sanding work.

 Do not apply too much pressure on the power
tool as this will cause overloading. The best
sanding results are achieved with moderate ap-
14
Heath hazard posed by dust



A Festool mobile dust extractor with an extractor
hose diameter of 27 mm or 36 mm (36 mm recom-
mended due to the reduced risk of clogging) can be
connected to the extractor connector [1-4].
 Festool CTL/M 36 E AC P L A N E X mobile dust
Recommendation: Use anti-static extractor hose!
This helps reduce the electric charge.

Working with the power tool

After finishing work

 To protect the sanding pad and the sanding

Dust extraction

WARNING
Always work with an extractor.
Comply with national regulations.
Wear a dust mask.
extractors are adapted to the quantity of dust
generated and permanently ensure the neces-
sary suction power.
plication pressure. The sanding performance
and quality depend mainly on selecting the cor-
rect abrasive.
Once you have finished the sanding work, set
the power tool down.
CAUTION! Do not set the power tool down
with the sanding head facing downwards –
always lay it on the floor so that it is on its
side with the brush ring facing down. Other-
wise the sanding pad could be deformed.
head, always transport and store the power tool
in the accompanying carry bag without the
sanding discs.