GYS GYSPACK AUTO Manual De Instrucciones página 11

Translation of the original instructions
GYSPACK AUTO / GYSPACK 400
• The terminal of the battery that is not connec-
ted to the car frame must be connected first.
The other connection must be made on the
car frame, far from the battery and the fuel
line. The battery charger must be connected
to the power supply network.
• After the charging process, disconnect the bat-
tery charger from the power supply network
and remove the connector from the car frame
and then the connector from the battery, in
this order.
Acid projection hazard!
• Wear safety goggles and protective gloves
• If your eyes or skin come into contact with bat-
tery acid, rinse the affected part of the body
with plenty of water and seek immediate me-
dical assistance.
Connection:
• Class II device (charger booster)
• Class III device (booster)
Connection to the mains must be made accor-
ding to the national installation regulations.
Maintenance:
• The power supply cable cannot be replaced.
If the cable is damaged,the device should not
be used.
• Service should be performed by a qualified
person
EN
11