Technical Parameters; Battery Check/Setting On A New Machine - Nilfisk SC530 53 BD GO Guia De Inicio Rapido

SC530 QUICK START GUIDE

TECHNICAL PARAMETERS

MODEL
Packing dimensions (Lx W x H)
Machine height
Machine length
Machine width (without squeegee)
Machine weight with empty tanks
(without batteries)
Gross vehicle weight (GVW)
Shipping weight
Solution tank capacity
Recovery tank capacity
Vacuum motor power
Vacuum capacity
Climbing capacity (Max)
Front wheel diameter
Rear wheel diameter
Sound level
Solution/water Flow
Working width
Squeegee width
Brush/pad diameter
Brush motor power
Brush speed
Brush/pad pressure(Max)
Drive motor power
Working speed
Voltage
Battery
Battery charger
Battery compartment size (L x W x H)
OPERATING GUIDE
WARNING!
On some points of the machine there are some adhesive plates indicating:
—DANGER!
—WARNING!
—CAUTION!
—CONSULTATION
While reading this Manual, the operator must pay particular attention to the symbols shown on the plates. Do
not cover these plates for any reason and immediately replace them if damaged.

BATTERY CHECK/SETTING ON A NEW MACHINE

WARNING!
The electric components of the machine can be seriously damaged if the batteries are either
improperly installed or connected. The batteries must be installed by qualified personnel only. Set
the function electronic board and the built-in battery charger according to the type of batteries
used (WET or GEL/AGM batteries).Check the batteries for damage before installation.
Disconnect the battery connector (38) and the battery charger plug (8). Handle the batteries with
great care. Install the battery terminal protection caps supplied with the machine.
Units SC530 53 B GO
mm
mm
mm
mm
Kg
Kg
Kg
Liter
Liter
Watt
mm H₂O
%
mm
mm
dB(A)
CL/M
MM
MM
MM
Watt
Rpm
Kg
Watt
Km/h
V
Ah
V/A
mm
6
SC530 53 BD GO
1370x600x1300
1080
1260
550
91
208
121
61
61
350
1200
2%
200
76
69±3
0 – 240
530
760
530/508
450
150
27
/
/
24V
12V 105 AhC5
24V/13A
350X350X300
ENGLISH
97
214
127
23
150
0-4.5