Adjusting The Balance Of Squeegee; Solution Or Washing Water Tank Filling; Machine Start And Stop; Starting The Machine - Nilfisk SC530 53 BD GO Guia De Inicio Rapido

SC530 QUICK START GUIDE

ADJUSTING THE BALANCE OF SQUEEGEE

1. Install the squeegee and screw up the nut (H), then connect the
vacuum hose (G) to the squeegee.
2. Adjust the squeegee by squeegee adjusting handle (A, Figure5).
a) If there is gap between the ground and middle section of rear
squeegee blade (B), adjust the knob (A) in counterclockwise
direction (F) until all section of rear squeegee blade good contact
with ground, the front blade touch the ground slightly.
b) If there is gap between the ground and both end section of rear
blade(C and D), adjust the knob (A) in clockwise direction (E)
until all section of rear blade good contact with the ground, the
front blade touch the ground slightly.

SOLUTION OR WASHING WATER TANK FILLING

WARNING!
Use only low-foam and non-flammable detergents,
intended for automatic scrubber applications.
Open the filter cover (28) to fill cleaning water or cleaning solvents to
solution tank. Don't overfill the tank. Stop filling when solution is
centimeters near the edge.

MACHINE START AND STOP

Starting the machine

1. Prepare the machine as shown in the previous paragraph.
2. Insert the ignitionkey (A, Figure. 6) and turn it to "I".Check that
the green warning light (B) turns on (charged battery). If the
yellow (C) or red warning light (D) turns on, turn the ignition key
back to "0" and charge the batteries (see the procedure in
Maintenance chapter).
3. Drive the machine to the working area:
• By pushing it with the hands on the handlebar (E) (only for
machine without traction).
• By pushing it with the hands on the handlebar (E) and pressing the
switch (F) to move forward, or pressing the switch (F) together
with the switch (G) to move backward (only for machine with
traction). The forward speed can be adjusted with the adjuster (H).
4. Lower the squeegee (I) with the lever (J).
5. Lower the brush/pad-holder deck (K) by lifting the pedal (L).
6. Press the brush/pad-holder switch (M) and the vacuum system
switch (N).
7. Press the washing water flow control switches (O) as necessary, depending on the type of cleaning to be performed.
8. Start cleaning:
• (only for machine without traction) by pushing the machine with the hands on the handlebar (E) and pressing the
switch (F).
• (only for machine with traction) by pushing the machine with the hands on the handlebar (E) and by pressing the
switch (F). If necessary, the forward speed can be adjusted with the adjuster (H).
NOTE
To move the machine forward, press either the left or right switch (F) or both.
H
C
E
F
O
K
I
8
ENGLISH
E
A
G
B
D
Figure 5
G D C B A
M N
Figure 6
F
H
F
H
J
L