ELICA NikolaTesla FIT 60 Manual De Montaje Y Modo De Empleo página 63

then scroll on the Selection bar (3), until the
" " " "
symbols C and 8 ,appear
the Display (2-FL) will show the current setting**
0 = 7.4 KW
1 = 4.5 KW
2 = 3.1 KW
** by default the setting is 7.4 KW
To change the Power Limitation setting
- press the Display (2) of the left front area (FL)
- then scroll on the Selection bar (3), to select the new setting
- to save the choice made, press the
for 2 seconds; a prolonged audible signal will be emitted to
confirm the successful setting
Bridge Zones
Thanks to the Bridge function, the cooking zones are able to
work in a combined manner, creating a single zone with the
same power level. This function allows evenly distributed
cooking with large-sized pots and pans.
The front "Master" cooking zone can be used in combination
with the corresponding "Secondary" cooking zone at the
back
(to check which zones are equipped with this function, see the
illustrated part of this manual).
To activate the Bridge Function:
- simultaneously select the two cooking zones you want
to use
- the Display (2) of the "Secondary" cooking zone shows the
symbol " "
- using the Selection bar (3), it will be possible to set the
Level (Power) of exercise, which will be shown in the
Display (2) of the "Master" cooking zone
- to deactivate the Bridge Function simply repeat the same
activation procedure
Note: the Cooking Timer Zone, activated during the Bridge
Function, causes the automatic shut-down of both cooking
zones, as in this case they are considered a single combined
area.
USING THE EXTRACTOR FAN
Switch-on
Press (touch) briefly
ON/OFF key (1),
ON/OFF (1) hob/extractor: the
symbol lights up;
continuing to press, all the available functions will become
visible for a few moments, e, after which only the main
ones will remain active; the others can be used, and will
be activated, subsequently, during use of the device.
IMPORTANT:
all the available functions will be illuminated with light
intensity, which will become more intense only when they
are activated.
Press again to turn off
Note: This function has priority over the others.
• Switching the extractor system off: Open the Flap touch
the selection Zone (12) to activate the extractor system.
Note: The extractor zone is fitted with a mechanical rotating
FLAP. The FLAP must be opened before switching on the
hood to activate the extractor system. The hood has a sensor
which when the extractor is on stops the motor automatically if
the FLAP is closed. Extraction only starts again when the
FLAP is reopened.
Extraction speed (power):
The extractor is equipped with 3 levels of extraction speed
(power)
Touch and slide your fingers along the Selection bar (3):
to the right to increase the level of power;
to the left to decrease the level of power.
The power level set will be displayed in the
Selection/Display area (12)
Power Booster
The product has 2 additional power levels (above level 3)
−
Power Booster 1 : timed for 15 min.
−
Power Booster 2 : timed for 5 min.
after which the power returns to the previously set level.
Touch and slide with the fingers along the Selection bar (3)
(over level 3) and activate the Power Booster 1
The Power Booster level 1 is indicated in the Selection /
Display area (12) with the number "4" flashing
Touch and slide with the fingers along the Selection bar (3)
(over level 3) and activate the Power Booster 2
The Power Booster level 2 is indicated in the Selection /
Display area (12) with the symbol"
Automatic operation
The hood will turn on at the most suitable speed, adapting the
extraction capacity to the maximum cooking level used in the
cooking zone.
When the cooking zones are switched off, the hood adapts its
extraction speed, decreasing it gradually, to eliminate residual
vapours and odours.
62
" flashing