General Settings - Psm - JVC KD-BT11 Manual De Instrucciones

General settings — PSM
You can change PSM (Preferred Setting Mode) items
listed in the table below and on pages 24 and 25.
1
Enter the PSM settings.
2
Select a PSM item.
Indications Item
(
DEMO • DEMO ON
Display
demonstration • DEMO OFF
CLOCK DISP *
1 • CLOCK ON
Clock display
• CLOCK OFF
CLOCK HOUR 1 – 12
Hour adjustment
CLOCK MIN 00 – 59
Minute adjustment
*
1 If the power supply is not interrupted by turning off the ignition key of your car, it is recommended that you select
"CLOCK OFF" to save the car's battery.
Setting, [reference page]
: Initial)
: The display demonstration will be activated automatically if no
operation is done for about 20 seconds, [4].
: Cancels.
: The clock time is always shown on the display when the power is
turned off.
: Cancels; pressing DISP will show the clock time for about 5 seconds
when the power is turned off, [4].
[Initial: 1 (1:00)], [4].
[Initial: 00 (1:00)], [4].
3
Adjust the PSM item selected.
4
Repeat steps 2 and 3 to adjust other PSM
items if necessary.
5
Finish the procedure.
Continued on the next page
SETTINGS 23