Adjusting The Sound - JVC KD-BT11 Manual De Instrucciones

3
Adjust the quality slope (Q).
Range/selectable items
Sound
elements
BASS
Frequency 60 Hz
80 Hz
100 Hz
200 Hz
Level (LVL) –06 to
+06
Q Q1.0
Q1.25
Q1.5
Q2.0
BASS: Bass MID: Mid-range TRE: Treble
5
Repeat steps 3 and 4 to adjust other sound
tones.
The adjustment made will be stored automatically.

Adjusting the sound

You can adjust the sound characteristics to your
preference.
1
2
22
MID TRE
500 Hz 10.0 kHz
1.0 kHz 12.5 kHz
1.5 kHz 15.0 kHz
2.5 kHz 17.5 kHz
–06 to –06 to
+06 +06
Q0.5 Fix
Q0.75
Q1.0
Q1.25
FADER *
2
Adjust the front and rear speaker
balance.
BALANCE *
3
Adjust the left and right speaker
balance.
LOUD *
4 (loudness)
Boost low and high frequencies to
produce a well-balanced sound at a
low volume level.
SUB.W *
1 (subwoofer)
Adjust the subwoofer output level.
VOL ADJ (volume adjust)
Adjust the volume level of each source
(except FM), compared to the FM
volume level. The volume level will
automatically increase or decrease
when you change the source.
• Before making an adjustment,
select the source you want to adjust.
VOLUME
Adjust the volume.
*
1 Displayed only when "L/O MODE" is set to "SUB.W"
(see page 24).
*
2 If you are using a two-speaker system, set the fader
level to "00."
*
3 This adjustment will not affect the subwoofer output.
*
4 Loudness setting will be applied to all sound modes.
*
5 Depending on the amplifier gain control setting. (See
page 25 for details.)
R06 to F06
L06 to R06
LOUD ON or
LOUD OFF
00 to 08,
initial: 04
–05 to +05,
initial: 00
00 to 50 or
00 to 30 *
5