Ryobi RTS31 Manual De Operación página 43

PROBLEM
Excess vibration.
Rip fence does not move
smoothly.
Rip fence does not lock at
rear.
TROUBLESHOOTING
CAUSE
Blade is out of balance.
Blade is damaged.
Saw is not mounted securely.
Work surface is uneven.
Blade is warped.
Rip fence not mounted correctly.
Rails are dirty or sticky.
Clamp screw is out of adjustment.
Clamp screw is out of adjustment.
Replace blade.
Replace blade.
Tighten all hardware.
Reposition on flat surface.
Adjust legs of leg stand.
Check saw blade installation. Replace blade if
necessary.
Remount the rip fence.
Clean and wax rails.
Adjust clamp screw counterclockwise.
Adjust clamp screw clockwise.
43
SOLUTION