Know Your Table Saw - Ryobi RTS31 Manual De Operación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

KNOW YOUR TABLE SAW

See Figure 2.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
ANTI-KICKBACK PAWLS - Kickback is a hazard in which
the workpiece is thrown back toward the operator. The teeth
on the anti-kickback pawls point away from the workpiece.
If the workpiece should be pulled back toward the operator,
the teeth dig into the wood to help prevent or reduce the
possibility of kickback.
BEVEL SCALE - The easy-to-read scale on the front of the
cabinet shows the exact blade angle.
BLADE - This saw is provided with a 10 in. carbide-tipped
blade. The blade is raised and lowered with the height/bevel
adjusting handwheel. Bevel angles are locked with the bevel
locking lever.
WARNING:
Do not use blades rated less than the speed of this tool.
Failure to heed this warning could result in personal
injury.
BLADE GUARD - Always keep the blade guard down over
the saw blade for through-sawing cuts.
BEVEL LOCKING LEVER - This lever, placed just under
the saw table surface on the front of the cabinet, locks the
angle setting of the blade.
FEATURES
HEIGHT/BEVEL ADJUSTING HANDWHEEL - Located on
the front of the cabinet, use this handwheel to lower and raise
the blade for height adjustments or blade replacement. This
handwheel also makes the adjustment for bevel angles.
LEG STAND - Attached to the table saw base, the leg stand
opens and closes with ease making transportation simple.
MITER FENCE WITH LOCK KNOB - The fence attaches
to the sliding miter table and can be angled for miter and
compound miter cuts as well as straight cuts such as cross
cuts and bevel cross cuts. With the locator pin in place, this
knob locks the miter fence to the sliding miter table at the
desired cutting angle.
RIP FENCE - A sturdy metal fence guides the workpiece
and is secured with the locking lever. Grooves run along the
top and sides of the rip fence for use with optional clamps
and accessories.
RIVING KNIFE - A removable metal piece of the blade
guard assembly, slightly thinner than the saw blade, which
helps keep the kerf open and prevent kickback. When in the
through sawing, or "up" position, it is higher than the saw
blade. When in the non-through sawing, or "down" position,
it is below the saw blade teeth.
SCALE - Located on the front rail, the easy-to-read scale
provides precise measurements for rip cuts.
SLIDING MITER TABLE - The sliding miter table moves
allowing the operator to slide the workpiece across the
saw table.
SLIDING TABLE EXTENSION - Located on the right side
of the saw table, this table extension gives the operator
additional support when cutting wide workpieces.
SWITCH ASSEMBLY - This saw has an easy access
power switch located below the front rail. To lock the switch
in the OFF position, remove the switch key from the switch.
Place the key in a location that is inaccessible to children
and others not qualified to use the tool.
10

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Rts31g

Tabla de contenido