Changing The Initial Setting Of Dvd - Sharp SD-AT100W Manual De Manejo

Changing the initial setting of DVD

SD-AT100W
ENGLISH
Turn on the TV, and switch the input to the "VIDEO 1" or "VIDEO 2" etc. accord-
ingly.
You can change the settings for TV mode, parental level, audio output, disc lan-
guage, and OSD language.
A new setting will be retained even if the unit is set to the stand-by mode. If you want
to restore or change the setting, reset it.
[Back]
The initial settings vary depending on the area. See the mark in the label attached on
the rear panel of the unit.
WA / WB / WN / WP / WW / WZ
E-21
1
Press the ON/STAND-BY button to turn the power on.
The startup screen appears.
2
After pressing the DVD/CD button, press the SETUP DVD button.
3
Press the or button to select the menu and press the ENT but-
ton.
WA/WB/WW/WZ:
TV mode
T V M O DE S E T U P
Parental level
T V M O D E :
4: 3
N T S C : N T S C
Audio output
Disc language
OSD language
SELECT
ENTER ENTER
4
Press the , , or button to change the setting and press the
ENT button.
Example: "OSD LANGUAGE SETUP" is selected
(The number of repetition depends on the setting item.)
To change other settings, begin from step 3.
5
Press the SETUP DVD button.
The new setting is memorised.
Notes:
! You cannot display the setup screen whilst a disc is playing.
! See page 25 for selecting another language for disc menus.
! The previous screen appears by pressing the RETURN
an item or setting.
02/2/27 SD-AT100W(X)E3.fm
WP/WN:
T V M O DE S E T U P
T V M O D E :
LB 4: 3 LB
P A L N T S C : N T S C
SELECT
RETURN ENTER ENTER RETURN
O S D L ANGU AGE S T U P E
L ANGU AGE : E NG L I S H
E NG L I S H
F R ANÇ A I S S V EN S K A
D E U T S CH N E DE R L AND S
I T A L I A NO
E S P A ÑO L
SELECT
ENTER ENTER RETURN
Repeat the operation as instructed.
button whilst selecting