Machine Usage - Blackstone GBK-700 1L Manual Del Usuario

D. Place the accelerator lever in the
maximum position
E. Pull the starter grip until the engine
starts up and go past the air lever
slowly to the OPEN position (normal
working position). Put the throttle lever
in the down position and let the engine
warm for 1 minute before starting to
work.
Normal working
position
6.4.2.2. WARM
ENGINE START
Follow the A & B steps on the Cold engine
start. Move the throttle to middle position
and pull the starter grip until it starts.
6.4.2.3. STOP THE ENGINE
Move the throttle lever to the down
position and the engine switch OFF. If
you put the shredder away, move the
lever to the passage of gasoline in the
OFF
on

7. MACHINE USAGE

.
Only use this machine for those jobs for
which it has been designed. The use of
.
Throttle
level
39
/160
the branches automatically. When
introducing wider branches, ensure that
the engine speed is sufficient. Cut the side
branches with a width of more than 3cm
from the main branch and introduce
separately. Long branches could hit you in
the face and therefore you must maintain a
safety distance and always use a face
protector.
SHREDDING TIPS
The hardness of the wood depends
on the type of wood, the time
between the pruning and the
shredding and the dryness of the
branches. For an optimum shredding, the
branches must be shredded just after the
pruning.
PAY ATTENTION TO THE FOLLOWING
COMMENTS:
Use the emergency button in case of
emergency. To turn off the machine
normally, first please place the engine in
idle speed and then put the contact in
position ¨o¨ (Off).
this machine for other uses is dangerous and
could cause damages to the user and/or the
machine.
Place the branches in the entry chute and
once they are inside, let them go. The
machine will suction
English