Look E POST 2 Manual De Montaje página 10

EN
CUTTING THE SEAT TUBE TO LENGTH
Your new bike requires its seat tube to be cut down to set it to your personal seat height. To have this
done it is preferable to refer to your LOOK approved retail outlet.
1. Insert the seatpost into the frame and set the horizontal position of the saddle.
2. Measure the seat height for the new bike, before cutting down, using the saddle.
3. Calculate the cut length "L" as follows:
L = saddle height on new bike – personal saddle height
4. Withdraw the seatpost.
5. Apply a strip of adhesive tape centred on length "L" in order to provide protection while cutting.
6. Fit the cutting jig at position "L" and tighten
the clamping screw to 3 Nm. (Fig. 13)
7. Cut the tube by running a hacksaw (24 or 32
teeth/inch) through the sawing slit. Turn the
bike stand so as to saw vertically.
8. Remove the jig, deburr the end of the tube
with fine glass paper. Check the end of the
tube is clean and paint-free.
ADJUSTING SEAT TUBE HEIGHT
You can adjust saddle height by adding
spacers. The E Post 2 is supplied with the
following spacers: 1 mm (qty.: 1) / 2 mm
(qty.: 2) / 5 mm (qty.: 1) / 10 mm (qty.: 3). The
maximum added height adjustment is 30 mm
(three 10 mm spacers stacked). To adjust
your saddle height:
1. Release the E Post 2 and withdraw it
from the frame.
2. Fit the rings onto the seatpost as shown
in Fig. 13.
3. Refit the seatpost using the procedure
described previously.
18
MAINTENANCE
Always clean your frame and accessories
with gentle soap or light detergent and water.
Use a soft cloth. Rinse with water and dry
with a cloth.
Do not use a high-pressure cleaner or
abrasive products.
AFTER-SALES SERVICE
Fig 13
L
Despite all the care that goes into our
manufacturing, if a defect appears or if
a repair is necessary, always take the
defective product and the warranty card to
your dealer.
WARRANTY
All LOOK accessories are guaranteed
one year starting on the date of purchase
against any fault or manufacturing defect.
Fig 14
To validate the guarantee, register on our
website: www.lookcycle.com
This guarantee remains limited to the initial
10 mm (x3)
buyer and a proof of purchase is required
(original bill).
5 mm (x1)
The guarantee concerns all faults or
manufacturing defects.
2 mm (x2)
The guarantee applies only if the product
is assembled in compliance with the above
1 mm (x1)
instructions.
The guarantee does not apply to defects
due to defective maintenance or abnormal
use.
In the same way the guarantee is null
if the product was subject to technical
modification by the user or if it was repaired,
repainted out of a LOOK authorized repair
centre.
The guarantee does not cover the following
cases:
* Defects caused by negligence or
insufficient maintenance
* Accidents
* Accessory and indirect damages
The assembling, disassembling, labour
hours, packaging and sending expenses
are not covered.
Do not pierce, paint or re-varnish.
Do not leave your accessory near a source
of heat.
ATTENTION :
Always inspect your accessory
before use.
If your LOOK accessory was subject
to any damage, bring the bike to your
LOOK retailer for an inspection.
Acquaint yourself with the laws in
force in the country where you are
if you ride at night. The reflectors
are not sufficient and do not replace
lighting.
Always use a helmet
Acquaint yourself with the Highway
Code and respect it.
Beware of road and traffic dangers.
EN
19