Electromagnetic Compatibility (Emc); Before Startup - Würth WIG 180 DC Traducción Del Manual De Instrucciones De Servicio Original

Electromagnetic compatibility
This appliance conforms to the current EMC standards.
Please note:
The appliance is intended for welding both
■
in commercial and industrial environments
(CISPR 11 class A). Using the appliance in an-
other environment (e.g. in a residential area) may
affect electrical equipment in that area.
During start-up, electromagnetic problems may be
■
caused in:
• Power cables, control lines, signal and telecom-
munication lines in the vicinity of the welding /
cutting appliance
• TV and radio transmitters and receivers
• Computers and other control equipment
• Security equipment in commercial buildings
(e.g. alarm systems)
• Cardiac pacemakers and hearing aids
• Calibrating and measuring equipment
• Appliances with insufficient interference resist-
ance
If any other facility or equipment in the sur-
roun��n� �re� �s �ffec�e�, ������on�l pro�ec-
tive barriers may become necessary.
The surrounding area to be taken into considera-
■
tion may extend beyond the boundaries of the
premises. This depends both on the type of the
building and on the other activities performed at
the site.
Always observe information and instructions
■
provided by the manufacturer when operating the
appliance. The company operating the appliance
is responsible for the setup and the operation of
the appliance.
If electromagnetic disturbances occur, the operating
company is responsible for the elimination of this
distubances (with technical help from the manufacturer
if necessary).
Product features (Fig. I)
1 Carrying strap
2 Displays / operating elements
3 Connecting socket – pole
4 Connecting socket + pole
5 Connecting socket remote control
6 Main switch
7 Mains lead
8 Gas connection
9 Air inlet
18
(EMC)
Techn�c�l spec�fic���ons
Item
Electrode welding range
TIG welding range
No-load voltage
Current setting
Duty cycle 100 %, 40%
Duty cycle 60 %, 40%
CDF at max. current, 40°C
Electrode diameter
Mains voltage
Frequency
Mains fuse
Max. current consumption Il
Max. rated power S1 (100%)
Power factor
Power cord
Mains plug
Protection class (IEC 529)
Cooling
Dimensions (L x W x H)
Weight
Protection class

Before startup

Transport
Always remove the mains plug before trans-
■
porting.
Carry the machine with the carrying strap [1]
■
and hold it horizontal.
Installation
Install the device in a safe place on a horizontal,
■
dry surface. Ensure that the ventilation slots of
the cooling ribs are always free.
0702 353 0
5 - 150 A
5 - 180 A
85 V
stepless
130 A
150 A
30%
Max. 4 mm dia.
230 V
50/60 Hz
16 A/tr
22,3 A
5.1 kVA
0.99 cos φ
3 x 2,5 mm
2
Schuko 16 A
IP 23
F
337 x 130 x
211 mm
6,5 kg
/ I