Adjusting Air Pressure; Loading Nails - Metabo HPT NV 75AN Instrucciones Y Manual De Seguridad

Clavador
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English
(3) First pull the Trigger.
Next, depress the Push Lever against the wood.
□ THE NAILER MUST NOT OPERATE.
(4) Without touching the Trigger, depress the Push Lever
against the wood.
Next, pull the Trigger.
□ THE NAILER MUST OPERATE.

ADJUSTING AIR PRESSURE

Adjust the air pressure at recommended operating
pressure 70 – 120 psi (4.9 – 8.3 bar 5 – 8.5 kgf/cm
according to the length of nails and the hardness of
workpiece.
The correct air pressure is the lowest pressure which will
do the job. Using the Nailer at a higher than required air
pressure unnecessarily over stresses the Nailer.

LOADING NAILS

● When loading nails into Nailer,
1) do not pull trigger;
2) do not depress push lever; and
3) keep Nailer pointed downward.
(1) Grip the nail guide and knob with fi nger.
Pull the knob down and swing the nail guide open.
And open the magazine cover.
Knob
Nail guide
14
WARNING
● Do not exceed
120 psi (8.3 bar
8.5 kgf/cm
WARNING
Magazine cover
(2) Adjust the position of the plate according to the nail
length.
The nail will not feed smoothly if the plate is not
correctly adjusted.
Magazine Nail holder
).
NOTE: Before loading nails in the magazine, adjust
2
the plate. If the magazine cover is forcibly
closed without adjusting the plate correctly,
the nail holder may be damaged.
1 Slide in vertical direction possible.
)
Lift or lower the nail holder to accept diff erent
2
length nails.
2 Adjust the plate to the nail length reference points
on the magazine cover and turn the nail holder 45
degrees.
Magazine
(3) Place the nail coil into the magazine.
Uncoil enough nails to reach the driving hole.
Magazine
Magazine cover
1
2
Nail holder
Nail holder
Nails
3
1
/
", 2"
4
1
1
2
/
", 2
/
"
4
2
3"

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Nv 75ansNv 75ans1Nv 75ans2

Tabla de contenido