Radio Reception - Teac AG-D8900 Manual Del Usuario

Audio Adjustments
6CH DIRECT INPUT
SPEAKERS
POWER
BASS/TREBLE
STANDBY/ON
Tone Controls
Main POWER switch and STANDBY/ON Button
When the main POWER switch is ON:
Press STANDBY/ON button to turn the power on. Press
it again to turn the system off (power standby mode).
The indicator lights up in power standby mode and
goes out when this unit is turned on.
6CH DIRECT INPUT Button
Select this when playing a DVD. "VID3/6CH" appears on
the display. Unlike other input signals, DVD signals
deliver their own surround information, and therefore
are reproduced with no direct processing by this unit.
SPEAKERS Select Buttons
With the unit in the STEREO mode, SPEAKERS A and B
can be selected simultaneously. If the unit is in any of
the SURROUND MODEs, or if "VID3/6CH" (DVD 6CH) is
selected as the input source using the 6CH DIRECT
INPUT button, speaker system A is selected
automatically.
BASS/TREBLE Tone Controls
These two tone controls – BASS and TREBLE – can be
used to obtain a "flat" frequency response or a tone
which suits your individual listening preference. The
BASS control adjusts low frequencies and the TREBLE
control adjusts the high frequencies.
BALANCE Control
This control is used to adjust the balance between the
left and right channels. Normally set to the center
position.
LOUDNESS Button
This button compensates for the non-linear response of
the human ear at low volumes. Set this switch to the
OFF position when listening at normal levels.
BALANCE
LOUDNESS
1. Select the TUNER function.
2. Select the AM or FM by pressing the BAND selector
3. Press the MODE button to change to TUNING mode.
4. Press the UP or DOWN TUNING/PRESET button
– 11 –

Radio Reception

Auto Tuning
1
POWER ON
button.
(The PRESET CH. indicator disappears from the
display.)
This button is used to select Tuning or Preset scan
mode.
(within 0.5 to 2 seconds). The next station
broadcasting at a frequency higher or lower than
that of the current station is automatically detected
and tuned in.
By pressing and holding the TUNING/PRESET button
for longer than 2 seconds, it will continue to control
(three times faster than normal speed).
FM MODE Button
Pressing this button alternates between Stereo
mode and Mono mode.
Stereo
FM stereo broadcasts are received in stereo and
the STEREO indicator lights in the display.
If FM broadcasts with weak signal strength are
received, the FM muting (–20 dB) function works
automatically to cut the signals, eliminating loud
noise.
Mono
To compensate for weak FM stereo reception,
select this mode. Reception will now be forced
monaural, reducing unwanted noise.
TUNED Indicator
''TUNED'' appears in the display when a
broadcast is correctly tuned in.
FM MODE
2
3 4